PROCESADOR CRESTRON MPC-M5

Control Engine
  Crestron® 2-Series; real-time, preemptive multi-threaded/multitasking kernel; FAT32 file system with long names
Memory
  SDRAM 32 MB
  NVRAM 256 KB
  Flash 8 MB
Communications
  Ethernet 10/100 Mpbs; auto-switching; auto-negotiating; auto-discovery; full/half duplex; TCP/IP; UDP/IP; CIP; DHCP; Private Network Mode; SSL; SNMP; IPv4; SMTP e-mail client; Web Server; installer setup via Crestron Toolbox™; supports all e-Control®, Crestron Mobile®, Crestron Fusion™ and RoomView® applications, IEEE 802.3af PoE compliant
  USB USB service port for computer console
  RS-232 2-way device control and monitoring up to 115.2k baud with software handshaking
  IR/Serial 1-way device control via infrared up to 1.2 MHz or serial TTL/RS-232 (0-5 Volts) up to 115.2k baud
Connectors
  LAN PoE (1) 8-wire RJ45;
 10Base-T/100Base-TX Ethernet port;
 802.3af Power over Ethernet compliant
  COM (3) captive screw terminals;
 Bidirectional RS-232 port;
 Up to 115.2k baud; software handshaking only
  IR (2) captive screw terminals;
 IR/Serial output port;
 IR output up to 1.2 MHz;
 1-way serial TTL/RS-232 (0-5 Volts) up to 115.2k baud
  RELAYS 1 – 2 (4) captive screw terminals comprising (2) normally open, isolated relays;
 Rated 1 Amp, 30 Volts AC/DC;
 MOV arc suppression across contacts
  I/O 1 – 2 (4) captive screw terminals comprising (2) programmable digital inputs;
 Supports sensing of contact-closures, voltage logic, and Crestron GLS Series occupancy sensors;
 Input Voltage Range: 0 to 24 Volts DC, referenced to GND;
 Logic Threshold: ≥3 Volts DC active/high, ≤1.8 Volt DC inactive/low;
 Input Impedance: 10k Ohms @ >5 Volts, 1M Ohms @ <5 Volts;
 Pull-up Resistor: 2.2k Ohms per input, always enabled;
 Pull-down Resistor: 2.5k Ohms per input, programmable, for use with GLS Series occupancy sensors;
 Maximum Power Output: 2 Watts (80 mA) @ 24 Volts DC, provides operating power for (2) Crestron GLS Series occupancy sensors
  Computer (1) Mini-USB Type B female (behind front cover);
 USB computer console port
  Ground (1) flying lead, chassis ground wire
Controls & Indicators
  Hard Keys (10) Programmable pushbuttons with backlit labeling
  Feedback Indicators (10) Programmable red LEDs (1 per hard key)
  HW-R (1) Recessed miniature pushbutton for hardware reset (reboots the processor)
  SW-R (1) Recessed miniature pushbutton (behind front cover) for software reset (restarts the SIMPL program)
  LAN PoE (rear) (2) green LEDs, bottom LED indicates Ethernet link status, top LED indicates Ethernet activity
IR Receiver
  Reception Frequency 36 to 38 kHz IR
  Formats Crestron format, RC5
  Range Up to 50 ft line of sight (typical), dependent upon angle, obstructions, IR interference, and IR remote signal strength 
Power Requirements
  Power over Ethernet IEEE 802.3af Class 2 PoE Powered Device
Environmental
  Temperature 32° to 104°F (0° to 40°C)
  Humidity 10% to 90% RH (non-condensing) 
  Heat Dissipation 14 BTU/hr
Enclosure
  Faceplate Plastic, textured, with polycarbonate label overlay
  Chassis Plastic with steel mounting plate
  Mounting Requires 2-gang plaster ring or electrical box (≥2.5 inch deep recommended)
Dimensions
  Height 4.50 in (115 mm)
  Width 6.10 in (155 mm)
  Depth 1.94 in (50 mm)
Weight
  15.0 oz (424 g)